Burg Wächter TSE 5000 Série Instructions De Montage Et Mode D'emploi page 33

When gluing the holder plate on the colour sight protection fi lm, the above
described conditions relating to cleanliness of surfaces and fi rmness of the
adhesive pad should be observed.
To provide for a bubble­free application of the colour sight protection fi lm,
please proceed as follows:
– Pour some water with a couple of drops of dishwashing detergent into a
glass, stir it cautiously free of foam, and then use it to moisture gently the
surface, on which the fi lm is to be applied.
– At an edge, pull off the white protective sheet from 1 cm of fi lm and
straighten it out. To change the position, lift this surface carefully and
attach it again as required.
– Then swipe the adhesive fi lm, e. g. with a plastic spatula, out from the
contact surface in the direction of protective sheet still attached.
Attention! Do not use more liquid than absolutely necessary.
– Slide the keypad in from above until the
locking peg of the mounting plate engages
into the keypad housing. In this way, the
keypad is protected against undesired removal.
– Perform a function test of the unit with the
door open. For this purpose, enter repeatedly
a valid opening code (e. g. PIN code,
fi ngerprint,...).
Battery replacement for the keypad
– Remove the housing cover on the bottom side by
loosing the 2 screws (Tx 8).
ME TSE PRIME English | 35