6 Before you fix the outer knob, please consider whether you wish to
use the attached cover panel for the profile cylinder section. If so, remove
the protective sheet and fix the cover panel onto the lock section.
7 Shift the outer knob into the required position on the shaft and fix it
with a clearance of at least 1 mm from the mounting using the hex!
8 The function test must be made with the door open.
Replacement of batteries – knob (inner side)
1 Using the attached hex key, loose the top locking screw on the cylinder
cover. It can be turned out only up to the opening of the cover and will
not fall out.
2 Open the cover
3 Replace the batteries. Make sure the batteries are inserted with the
correct polarity, indicated at the marked point on the housing.
4 Replace the cover.
ME
TSE PRIME
English | 39