Burg Wächter TSE 5000 Série Instructions De Montage Et Mode D'emploi page 25

Administrator code
The code is delivered separately on a sticker. It shall be carefully preserved.
Attention: If it is lost, any programming changes or the use of all the
administrator functions are no more possible.
Power supply for the cylinder
– 2 x MIGNON LR6 AA ALKALINE
Power supply for the E-KEY
– 1 x CR 2032
Optical signalling
The optical signal in the form of a LED is incorporated in the knob on the
inner side of the door. This LED informs you on the following:
– 1 xbrief: lock has been opened
– 2 xbrief: lock has been shut
– every 5 sec. 1 x brief: permanent opening activated
– 1 x brief, 1 x long, 2 sec. pause, repetition: lock in programming mode
– 5 x brief, 2 sec. pause, repetition after 20 sec.: cylinder battery empty
Opening
The TSE, depending on thr version can be operated by use of a 6-digit code,
or with fingerprint or with a TSE E­KEY.
Opening with Pincode
– Press the
– Enter the 6 digit PIN code (factory-set to 1-2-3-4-5-6). The display indicates
"Please use rotating knob!" and the LED integrated in the cylinder flashes
once when the opening is successful.
– Turn the cylinder knob.
Opening with E-KEY
– Press the button on the TSE E-KEY. The LED which is integrated
in the cylinder flashes once upon successful opening.
– Turn the cylinder knob.
When using the opening procedure with an E-KEY, please note that
the keypad should not be previously activated using the
Opening with Fingerprint
– Press the
– Move the registered finger from the top to the bottom centrally over the
sensor. The display indicates "Please use rotating knob!" and the LED
integrated in the cylinder flashes once when opening is successful.
– Turn the cylinder knob.
ME TSE PRIME
key
key
key!
English | 27