Cleaning Instruction - Burg Wächter TSE 5000 Série Instructions De Montage Et Mode D'emploi

Cleaning instruction

The surface finish of the keypad prevents adherence of impurities. Dust or
dirt can be removed from the surfaces using a damp cloth.
No alcohol-based detergents (spirit, SIDOLIN® etc.) or aggressive detergents
(acetone etc.) may be used, as they can damage the surface or the sensor.
Assembly manual for TSE Cylinder
The installation of the TSE cylinder is described below.
Please read this Assembly Manual carefully before the assembly and then
store it in at a safe place.
The cylinder has a special detent system, offering you a possibility of using
the cylinder for doors with a thickness up to 120 mm (60/60 mm, measured
at the central detent bolt). No prior adjustment is necessary.
Attention:
Be careful to not bang the knob anywhere, as the knob can break in
such case. The lock should not be greased or oiled.
An incorporated locking screw in each knob is to fix the rotary knobs.
Attention: Never pull the inner knob completely from the shaft, as
this might cause damage to the electronics! The locking screw,
which ensures the detent on the shaft, may be loosened only lightly
and it always remains in the plastic knob, providing protection
against pulling it out.
Outer side
Outer knob
Cover
Remark
The base size of the cylinder is 30 mm per side. When delivered, the cylinder
is completely collapsed (the smallest door thickness). Before you insert the
cylinder into the door, you should adjust it to your door thickness.
When installing the cylinder, proceed as follows:
1 Take a rough measurement of the door thickness (incl. fittings)
2 Pull the outer knob from the shaft, move the inner knob over the detent
system (spacing 2.85 mm) to the required dimension.
ME TSE PRIME
Adapter 2 Adapter 1
Inner side
Inner knob
Detent bolt Locking screw
for fixation onto
Schematic
illustration of an
assembled cylinder
incl. the two
adapter parts.
the shaft
English | 37