Console (Fig F); Explanation Of Buttons; Explanation Display Functions - Tunturi F20 Mode D'emploi

English

Console (fig F)

1. Display
2. Tablet/ book support
3. Buttons
⚠ CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered with drops of
sweat.
• Do not lean on the console.
• Only touch the display with the tip of your finger. Make sure that
your nails or sharp objects do not touch the display.
‼ NOTE
• The console switches to standby mode when the equipment is
not used for 4 minutes. If the console is in standby mode, the
display shows the room temperature

Explanation of buttons

Up (Dail)
- Press UP Key to increase value. Press and hold the key to increase
value faster.
- TIME setting range: 00:00~99:00 (Each increment is 1:00)
- CAL setting range: 0~9990 (Each increment is 10)
- DIST setting range: 0.00~99.50 (Each increment is 0.5)
- PULSE setting range: 0-30~230 (Each increment is 1)
Down (Dail)
- Press DOWN Key to decrease value. Press and hold the key to
decrease the value faster.
- TIME setting range: 00:00~99:00 (Each decrement is 1:00)
- CAL setting range: 0~9990 (Each decrement is 10)
- DIST setting range: 0.00~99.50 (Each decrement is 0.5)
- PULSE setting range: 0-30~230 (Each decrement is 1)
Mode/ Enter
- Choose each function by pressing MODE/ENTER key.
- Press and hold MODE/ENTER key for 2 seconds to reset all
functions (same feature as the reset key if press for 2 seconds).
Reset
- In setting mode, press RESET key once to reset the current function
figures.
- Press RESET key and hold for 2 seconds to reset all function figures
Recovery
- After the console detects pulse signal, press the RECOVERY key to
enter recovery mode to monitor heart rate recovery ability
Body Fat
- Test body fat% and BMI.
Total reset
- Console will restart over.

Explanation Display functions

Scan
- In SCAN mode, press MODE/ENTER key to choose functions.
- Automatically scan through each mode in sequence every 6
seconds.
- The sequence of display when press MODE/ENTER key : TIME »
DIST » CAL » PULSE » RPM/SPEED
Speed
- Range 0.0 ~ 99.9
- Without any signal being transmitted into the monitor for 4
seconds during workout, SPEED will display "0.0"
RPM
- Range 0 ~ 999
- Without any signal being transmitted into the monitor for 4
seconds during workout, RPM will display "0"
Time
- Without setting the target value, time will count up.
- When setting the target value, time will count down from your
target time to 0 and alarm will sound or flash.
- Without any signal being transmitted into the monitor for 4
seconds during workout, time will STOP
- Range 0:00~99:59
Distance
- Without setting the target value, distance will count up.
- When setting the target value, distance will count down from your
target distance to 0 with an alarm sound or flash.
- Range 0.00~99.99
Calories
- Without setting the target value, calorie will count up.
- When setting the target value, calories will count down from your
target calorie to 0 with an alarm sound or flash.
- Range 0~9999
‼ NOTE
• This data is a rough guide for comparison of different exercise
sessions which cannot be used in medical treatment.
Pulse
- Current pulse will display after 6 seconds when detected by the
console.
- Without any pulse signal for 6 seconds, console will display "P".
- Pulse alarm will sound when current pulse is over the target pulse.
- Range 0-30~230 BPM
1 8