Set The Steering Wheel Position; Operation; Driving - Kärcher MIC D Mode D'emploi

5.5

Set the steering wheel position

6

Operation

DANGER
Risk of burns, risk of crushing!
Ensure that nobody stays in the vicinity of the articulat-

ed steering during operation
Only use the vehicle if all panels are attached.

WARNING
Risk of damage due to overheated hydraulic oil or over-
heated motor!
6.1

Driving

DANGER
Risk of accident!
Do not adjust the steering wheel position while driving.

1 Steering wheel inclination adjustment pedal
2 Clamping steering wheel height adjustment
The inclination and height of the steering wheel can be ad-
justed.
Angle adjustment: Push the steering wheel angle ad-

justment pedal and release the pedal when the desired
position is reached.
Height adjustment: Push the clamping lever down and

adjust the steering wheel to the desired height, then
pull the clamping lever back up and clamp it in place.
In case of excessive hydraulic oil temperature or exces-

sive cooling water temperature, set the motor speed to
idling (do not switch off the motor) and perform the
measures described in Chapter "Faults".
Risk of damage due to missing lubrication!
If the warning light for the oil pressure lights up during

operation, immediately switch off the motor and rectify
the fault.
1 Drive pedal
2 Brake pedal
3 Steering wheel inclination adjustment pedal
4 Inch pedal
5 Container brake fluid
MDC variant (mechanically controlled drive)
1 Accelerator pedal forward / reverse
2 Brake pedal
3 Steering wheel inclination adjustment pedal
4 Parking brake pedal
5 Locking / unlocking lever parking brake
22
-
EN 79