Double-Acting Hydraulic Connections Aux (Rear); Work Hydraulics Pto (Front) - Kärcher MIC D Mode D'emploi

6.8

Double-acting hydraulic connections AUX (rear)

6.9

Work hydraulics PTO (front)

6.9.1 Override floating position switch
90
1 Double-acting control hydraulics connection AUX, dou-
ble-acting
The operation takes place via the control lever.
2 Double-acting control hydraulics connection AUX (op-
tional)
The operation takes place with the same control lever
as for connection 1, to activate it, the switch "AUX rear/
lifting platform" must be pushed.
MDC variant (mechanically controlled drive)
The control of the hydraulic connections takes place via

the control lever for AUX - Green/Grey/Purple
AUX Grey/Purple - Switch on switch 2 (position 1).

1 Work hydraulics PTO (40 litres/min)
2 Work hydraulics PTO (80 litres/min)
3 Return
4 Leakage coupling
The front PTO only works if the front power lift is in the
floating position.
The oil flow is preselected via the PTO selector switch.

The hydraulic PTO is switched on via the PTO on/off

switch.
DANGER
Mortal danger due to rotating parts!
Keep a safety distance to working attachments.

1 Red safety button
2 Override floating position switch
For certain applications it is necessary to activate the front
attachment without the floating position being activated.
Proceed as follows:
To activate the PTO (while floating position is switched

off), slide the red safety button on the switch towards
the front, then push the override floating position
switch.
Note
The PTO will shut down when the switch is switched off.
33
-
EN