Kärcher MIC D Mode D'emploi page 85

6.3.2 Setting the lowering speed of the front power lift
6.3.3 Attachment discharge and vibration damping (optional)
Switch off PTO.

Turn the rotary knob for the lowering speed in a clock-

wise direction (direction B) - the lowering speed de-
creases.
Turn the rotary knob for the lowering speed in a coun-

ter-clockwise direction (direction A) - the lowering
speed increases.
1 Switch attachment discharge
Caution! This switch is responsible for the vibration damp-
ing as well as for the attachment discharge (either or, both
options are not possible at the same time).
6.3.3.1 Attachment discharge
The attachment discharge is used to move the load from
an attachment that is installed on the front power lift to-
wards the front axle of the vehicle.
For example: When using a mower deck, the ground forc-
es are reduced by the mower deck in order to reduce the
damage to the ground caused by slipping wheels, espe-
cially uphill.
Switching on the attachment discharge: Push the at-

tachment discharge switch (at the rear console).
1 Rotary knob attachment discharge
The shifting of the centre of gravity can be changed via the
rotary knob attachment discharge.
Turning in a clockwise direction - More weight on the

front axle
Turning in a counter-clockwise direction - Less weight

on the front axle
Note
If the attachment is raised while the attachment discharge
is switched on, it acts like a load stabilisation during driv-
ing.
6.3.3.2 Vibration damping (option)
The vibration damping ensures more comfortable and sta-
ble driving during transport runs with raised attachment on
the front power lift.
To switch it on or off, push the attachment discharge

switch.
28
-
EN 85