Work Hydraulics Pto (Rear); Electric Pto (Front) - Kärcher MIC D Mode D'emploi

6.10 Work hydraulics PTO (rear)

6.11 Electric PTO (front)

1 Work hydraulics PTO (40 litres/min)
2 Work hydraulics PTO (80 litres/min)
3 Return
4 Leakage coupling
5 Not assigned
The work hydraulics PTO is enabled via the "Hydraulic
connections" selector switch in the console
The oil flow is preselected via the PTO selector switch.

The hydraulic PTO is switched on via the PTO on/off

switch.
1 Electric PTO
The following table shows the PIN assignment of the elec-
tric PTO in the front.
PIN Name
A Ground
B +12V from F05
C +12V from F05
D Output 1
E Output 2
F not assigned
The operation takes place with the "Electric PTO front"
switch
Push the switch upwards, output 1 is activated.

Push the switch down, output 2 is activated.

34
-
EN
Value
20 A from
F05
91