Description Of The Appliance; Assembly; Commissioning - Kärcher FC 3 Cordless Mode D'emploi

 Do not use the appliance for
cleaning of carpets or carpet-
ed floors.
 Do not use the appliance over
the floor grilles of convector
heaters. The appliance is not
able to take in the water dis-
charged when used above
grilles.
 In case of longer breaks in op-
eration and after use, switch off
the device at the main switch /
device switch and pull the
charger's mains plug.
 Do not operate the appliance
at temperatures below 0 °C.
 Protect the unit from rain. Do
not store outside.

Description of the Appliance

1 ON/OFF switch
2 Handle
3 Wall anti-slip handle
4 Fresh water tank
5 Fresh water tank recessed grip
6 Charging socket
7 Waste water tank
8 Recessed grip cleaning roller
9 Cleaning rollers
10 Floor head cover
11 Floor head cover lock
12 Battery indicator
13 Charger with charging cable
14 Parking station
15 Roller storage
16 ** Detergent
17 ** Detergent
18 ** Detergent
19 Defoamer
9 ** Cleaning rollers
** FC 3 Cordless Premium

Assembly

ATTENTION
Take care to ensure that the power cable lies fully in the
guide rail before fitting the handle bar.
Illustration
 Insert handle into the basic unit as far as it goes un-
til it engages audibly.
The handle must sit snugly into the appliance.
RM 534 30 ml
RM 536 500 ml
RM 537 500 ml
FoamStop 30 ml
2x
EN

Commissioning

Illustration
 Place the device in the parking station for safe stor-
age.
Installing the rollers
Illustration
 Screw the cleaning rollers onto the threaded rod up
to the mechanical stop.
 Pay attention to the colour-codes on the inside of
the roller and roller holder on the appliance (e.g.
blue should match up with blue).
 After the installation, check to ensure that the
cleaning rollers sit snugly.
Charging process
Illustration
 Plug the charging cable of the charger into the
charging socket on the device.
 Plug the mains plug of the charger into a power out-
let.
Illustration
 The LED indicator lights display the battery's cur-
rent charging state.
 All 3 LED indicator lights flash from bottom to top
when charging a completely empty battery.
 The lowermost LED lights up continuously when
the battery is 1/3 charged, the two upper LEDs con-
tinue to flash.
 When the battery is 2/3 charged, the two lower
LEDs light up continuously, the uppermost LED
continues to flash.
 After the battery has been fully charged, the 3 LED
indicator lights will continue to light constantly for
60 minutes. After this time, the LED indicator lights
go out.
Illustration
 Once the battery is charged, pull the mains plug out
of the socket and the charging cable out of the
charging socket.
Fill fresh water reservoir
Illustration
 Place the device in the parking station.
Illustration
 Grasp the fresh water tank by the recessed grip
and remove it from the device.
Illustration
 Open the tank cap and turn it to the side.
Illustration
 Fill the fresh water tank with cold or lukewarm tap
water.
 KÄRCHER detergents/care agents can also be
added to the fresh water tank as required.*
 Do not exceed the "MAX" marking when filling.
 Close tank lock.
Illustration
 Insert the fresh water container into the appliance.
 The fresh water tank must sit snugly into the appli-
ance.
ATTENTION
*Follow the recommended dosage instructions on the
detergent/care agent.
– 10
19