Signalink USB Manuel D'installation Et Fonctionnement page 46

13- - - - pin DIN Accessory Port Connector 13 pin DIN Accessory Port Connector
13 13 pin DIN Accessory Port Connector pin DIN Accessory Port Connector
13-pin Accessory Port, however there are two possible jumper settings. If your radio is not listed in Figure 1 or Figure 2, then you will need to try
both jumper settings to determine which PTT configuration your radio requires. We suggest that you try the settings in Figure 1 first.
NOT be damaged if you install the PTT j NOT NOT NOT be damaged if you install the PTT jumper using the wrong configuration be damaged if you install the PTT j be damaged if you install the PTT j
jumpers, be sure to set the sound card audio levels as outlined in the SignaLink manual. If you do not set the levels correctly, then the SignaLink
may not transmit, and you might mistake the problem for incorrect jumper settings. Note that external power is required for the SignaLink Model SL-
1+.
Figure 1 Figure 1
Figure 1 Figure 1
This configuration is the most common and
works with early Kenwood radios such as the
TS-140, TS-450S, TS-850, TS-870 and TS-
950. Some newer radios such as the TS-
570D, TS-590S, TS-990 and TS-2000/X also
use these settings.
TOP
(use SLUSB13K, SL1+13PK or SLCAB13K) (use SLUSB13K, SL1+13PK or SLCAB13K)
(use SLUSB13K, SL1+13PK or SLCAB13K) (use SLUSB13K, SL1+13PK or SLCAB13K)
umper using the wrong configuration - - - - you just won't be able to transmit! umper using the wrong configuration umper using the wrong configuration
Figure 2 Figure 2
Figure 2 Figure 2
This configuration is less common and is used by
some newer radios (TS-690 for example) and
some older radios such as the TS-440. These
settings are identical to those in Figure 1, except
for the PTT jumper, which has been replaced by a
diode module (supplied with cable).
Our 13-pin cable works with ALL
you just won't be able to transmit! you just won't be able to transmit! you just won't be able to transmit!
TS-2000 users should set menu item 50E to Main, and 50F to
1200 Baud. Menu 50B can be used to increase the radio's
power output if it is too low, and menu 50C can be used to
adjust the Receive Audio level.. We suggest that you change
these menu items even if they already appear to be set correctly
(set 50F to 9600, and then back to 1200, etc.).
TS-570 users should set Menu #33 to 1 or 2 (a setting of zero
will result in no transmit power). Menu #34 should be set at 4-
5 and can be increased to provide more Receive Audio if
needed.
TS-940 users need to use the jumper settings shown in figure 1,
except for the PTT jumper. The PTT jumper should be
connected to pin #4 instead of pin #3.
TS-440 users please note that your radio's Mic Gain control
will affect your power output. We suggest setting this control
to 50% and then adjust it as needed so that the SignaLink's TX
knob can be used to adjust the power output properly.
ALL Kenwood radio's that have a
ALL ALL
Your radio will Your radio will
Your radio will Your radio will
After you have installed the
Notes