Publicité
Les langues disponibles
Les langues disponibles
8 8 8 8 - - - - Pin Round Mic Connector
Pin Round Mic Connector
Pin Round Mic Connector
Pin Round Mic Connector
(use SLUSB8R, SL1+8R, SL1
(us
(us
(us
JP- - - - 1 1 1 1
JP
JP
JP
Pin-out
Pin 1 - Mic
Pin 2 - PTT
Pin 3 - NC
Pin 4 - NC
Pin 5 - NC
Pin 6 - +5VDC
Pin 7 - GND
Pin 8 - GND
Elecraft K3 rear panel Audio In, Audio Out and PTT connectors
Elecraft K3 rear panel Audio In, Audio Out and PTT connectors
Elecraft K3 rear panel Audio In, Audio Out and PTT connectors
Elecraft K3 rear panel Audio In, Audio Out and PTT connectors
JP- - - - 1 1 1 1
JP
JP
JP
Pin-out
Pin 1 - SPKR
Pin 2 - GND
Pin 3 - Mic
Pin 4 - PTT
Pin 5 - GND
Pin 6 - GND
Pin 7 - NC
Pin 8 - NC
e SLUSB8R, SL1+8R, SL1- - - - 8R or SLCAB8R)
e SLUSB8R, SL1+8R, SL1
e SLUSB8R, SL1+8R, SL1
8R or SLCAB8R)
8R or SLCAB8R)
8R or SLCAB8R)
Radio Models
K2
K3
Radio Models
K3
only
Elecraft
Notes
The Mic jack on the K2 can be wired a number of
different ways, so before installing the jumper
wires, you MUST verify that the pin-out of your K2
matches that shown here.
Sufficient power is not available on this connector,
so you will need to use external power for the
SignaLink Model SL-1+.
(use SLUSBK3, SL1+K3, or SLCABK3)
(use SLUSBK3, SL1+K3, or SLCABK3)
(use SLUSBK3, SL1+K3, or SLCABK3)
(use SLUSBK3, SL1+K3, or SLCABK3)
Notes
Some customers have found that the K3's "Line
In" gain (menu setting) is set to zero by default,
thereby resulting in no power output when
transmitting. If up experience this problem, then
please consult your radio manual for instructions
on turning up this control.
Note that the K3 also has a menu setting for the
"Line Out" level, which can be turned up if
needed to increase the RX Audio going into the
SignaLink.
Publicité
