Publicité
Les langues disponibles
Les langues disponibles
8 8 8 8 - - - - pin DIN Accessory Port Connector
pin DIN Accessory Port Connector
pin DIN Accessory Port Connector
pin DIN Accessory Port Connector
IMPORTANT:
IMPORTANT: This diagram is for the ACCY
IMPORTANT:
IMPORTANT:
This diagram is for the ACCY
This diagram is for the ACCY PORT only.
This diagram is for the ACCY
diagram above under "8- - - - Pin Round MIC Connector".
diagram above under "8
Pin Round MIC Connector".
diagram above under "8
diagram above under "8
Pin Round MIC Connector".
Pin Round MIC Connector".
JP- - - - 1 1 1 1
JP
JP
JP
Pin-out
Pin 1 - RTTY or N/C
Pin 2 - Ground
Pin 3 - Send
Pin 4 - Mod In
Pin 5 - AF Out
Pin 6 - Squelch
Pin 7 - +13.8V
Pin 8 - ALC
(use SLUSB8PD, SL1+8PD or SLCAB8PD)
(use SLUSB8PD, SL1+8PD or SLCAB8PD)
(use SLUSB8PD, SL1+8PD or SLCAB8PD)
(use SLUSB8PD, SL1+8PD or SLCAB8PD)
PORT only. If the SignaLink is attached to your radio's 8
PORT only.
PORT only.
If the SignaLink is attached to your radio's 8
If the SignaLink is attached to your radio's 8- - - - pin Round Mic Jack, then please see the
If the SignaLink is attached to your radio's 8
Radio Models
IC-275A
IC-575A/H
IC-707
IC-725/726
IC-728/729
IC-735/736/737/738
IC-7400
IC-746**
IC-746PRO**
IC-756 / 756PRO
IC-756PROII / III
IC-761/765
IC-775/775DSP
IC-781
IC-7600/7700/7800
IC-820H/821H
IC-910H
IC-M600
IC-M700PRO
IC-M710
IC-M802
pin Round Mic Jack, then please see the
pin Round Mic Jack, then please see the
pin Round Mic Jack, then please see the
Notes
IC-756PRO users should use digital mode "D-USB"
or "D-LSB".
**Some customers have reported that the IC-746
(early model only) does NOT mute the Mic when
keyed from the Accy Port. If this is the case with
your radio, then you will need to turn the radio's Mic
Gain down and/or unplug the microphone.
**Due to the design of the IC-746PRO, this jack does
NOT support VHF operation. If you want to operate
both HF and VHF, then you'll need to use the 6-pin
mini-DIN Data Port instead.
**IC-746PRO users should use "USB/LSB Data"
mode (not regular USB/LSB).
IC-820H users need to set the Modulation Input
Sensitivity switch to "Low", and the Baud Rate
Selection switch to "AMOD".
Publicité
