Deleting The Pairing Of Bluetooth Devices; Troubleshooting Guide - Unitron uDirect 3 Guide Rapide

Deleting the pairing of Bluetooth
devices
If you encounter issues with one of the paired
devices, or if a device stops connecting to your
uDirect 3, you may consider deleting the pairing
of devices to the uDirect 3.
1. Turn on your uDirect 3.
2. Press and hold the (
( ) buttons for ten seconds
until the blue rapid blinking
audio indicator stops.
3. Also delete the uDirect 3
pairing entries on your
mobile phone before any
re-pairing.
4. Repeat the pairing procedure.

Deleting the pairing of Bluetooth devices

removes the ability to connect to these devices.
You will need to perform the pairing process
again if you wish to reconnect.
54
) and

Troubleshooting guide

Cause
During Bluetooth pairing my other device is prompting
for a code, what do I have to enter?
The pairing code is
required for the initial
coupling of uDirect 3
with your Bluetooth
device (pairing)
I hear intermittency during audio streaming via
uDirect 3
The Bluetooth
device is too far away,
or worn in a back pocket
(body shielding)
uDirect 3 searches
for known devices
for two minutes after
switching on
A phone connected
to other devices, such
as a PC, may not be
able to continuously
stream music
Possible remedy
The uDirect 3 pairing code
is "0000" (four zeros)
Do not to exceed the
maximum distance 5-10 m
(15-30 ft) and keep Bluetooth
devices in front of you
After two minutes, uDirect 3
will stop searching and the
intermittency will stop
When using your Bluetooth
phone as music player,
disconnect it from other
devices, such as PCs
55