Step 7: Adjusting The Volume Of The Tv Signal - Unitron uTV 2 Manuel D'utilisation

If the uTV 2 status light (g):
blinks green, make sure the audio input to
the uTV 2 is properly connected and the input
volume is set to a 75% level.
is green, make sure uDirect 2 is switched ON,
both ends of the neckloop are plugged in and
the devices are paired.
blinks blue, you are in pause mode. Press
the uDirect 2 access ( ) button to resume
streaming.
Step 7: Adjusting the volume of the
TV signal
First, set the volume of the TV speakers at the
level to suit other viewers.
If the uTV 2 is connected to your TV with the
RCA/Cinch cable (i) or the SCART adaptor (k),
adjust the volume via the uTV 2 volume control
(b) and (c) (fig. 5) until the sound is comfortable.
16
For daily usage and fine-tuning of the sound,
use the volume (
uDirect 2.
If your uTV 2 is connected to the headphone
socket of your TV, you may also use your TV
remote control to adjust volume via the TV
directly. Refer to the TV user guide for more
details on setting the TV volume.
If your TV is connected to a satellite receiver or
a set-top box, make sure the volumes of these
additional devices are set to a 75% level for
best audio quality results.
(c) (b)
Fig. 5
) buttons (fig. 6) of
Fig. 6
17