Turning The Udirect 2 On And Off; Battery Status Information; Udirect 2 Bluetooth Pairing - Unitron uDirect 2 Ensemble Guide

Turning the uDirect 2 ON and OFF
Slide the power switch
( ) as shown to turn
the uDirect 2 ON or OFF.
Switch the uDirect 2
OFF when not in use or if in storage or during
transportation.
For operational use switch the uDirect 2 ON.

Battery status information

The power indicator shows the following:
Green for 2 seconds
Blink red then solid
for 2 seconds
Slow blink green
Short blink red
No blinking just after
switching ON
If the neckloop has been unplugged for more
than 2 minutes, the power indicator is only lit
as long as a button is pressed.
6
OFF ON
Switching ON
Switching OFF
Normal operation
<20% battery left,
please charge
Charge for at least
2 hours
uDirect 2 Bluetooth pairing
1. Switch ON ( ) the uDirect 2.
2. Press and hold the connect (
( ) buttons simultaneously for 2 seconds until
the audio indicator starts to rapidly blink blue.
2 sec
3. Start the pairing process on the Bluetooth
device (e.g., phone) within 1 minute according
to the devices user guide and
use code "0000" when prompted.
4. After successful pairing, the audio indicator
will stop rapidly blinking blue.
The pairing process does not require the neckloop
to be plugged in. For streaming and Bluetooth
connection, the neckloop is mandatory.
When pairing to a cellular phone, we recommend
disabling the phone key tones and SMS alerts.
) and volume
®
7