Making Phone Calls; Incoming Calls - Unitron uDirect 3 Guide Rapide

Some phones are configured to play key-press
tones, SMS announcements and confirmation
beeps to the uDirect 3.
If this is set you will hear these tones
interrupting any active audio streaming through
your hearing aids. Your hearing aids may briefly
switch to streaming mode which may be
unwanted.
Please refer to your phone user guide for
information about disabling these sounds.
Phone calls via Bluetooth will always take priority
over other audio sources on your uDirect 3.
It is not possible to change hearing aid programs
using uDirect 3 during a phone call.
You will hear the caller's voice through both
hearing aids.

Making phone calls

Use the phone keypad to enter the number and
press the phone dialing button.
When connected, you will hear the dialing tone
through your hearing aids after approximately
three seconds.
28
Using cordless phones (DECT) or older phones
with headset profile only
If your phone only supports the headset
profile (HSP), the connection must be initiated
manually for outgoing calls. This often applies
to cordless home phones (DECT standard).
For these phones, the audio indicator might not
blink blue even if the phone is paired.
1. Dial the number you want to dial on your
phone, or select it from the phone book.
2. Briefly press the connect (
wait five seconds.
3. The dialing process will automatically start
and the audio indicator will turn solid blue.
You may hear a confirmation beep through
your hearing aids.

Incoming calls

The uDirect 3 must be switched on, paired to
the phone and worn correctly.
When a call is received on your phone, the
uDirect 3 audio indicator will show a solid
blue light, and you will hear the ringtone
signal through your hearing aids.
) button, then
29