Before You Start; Tools; Installing The Washer; Step 1: Remove The Shipping Brace And Shipping Plug - Alliance Laundry Systems W446I Manuel D'installation

Before You Start

Tools

For most installations, the basic tools you will need
are:
1
1 Wrench
2 Screwdriver
3 Pliers
4 Level
Figure 1
NOTE: If the washer is delivered on a cold day
(below freezing), or is stored in an unheated room
or area during the cold months, do not attempt to
operate it until the washer has had a chance to
warm up.
IMPORTANT: Install dryer before washer. This
allows room for attaching exhaust duct.
201940
2
4
D074I
D074I
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Installing the Washer

Step 1: Remove the Shipping Brace and
Shipping Plug
Remove the shipping brace from under the lid.
The shipping plug will be released from the base of the
washer when removing the cardboard base from the
washer. Refer to Figure 2.
3
The shipping brace and plug should be saved and must
be reinstalled whenever washer is moved or
transported to a new location. This will prevent
damage to washer components.
Do not tilt washer to front or sides when moving.
Refer to User-Maintenance section for instructions on
reinstalling shipping brace and shipping plug.
1
3
1 Shipping Brace
2 Shipping Plug
3 Cardboard Base
Installation
2
TLW2052N
TLW2052N
Figure 2
7