Alliance Laundry Systems W446I Manuel D'installation page 11

Recommended cold water temperature is 10° to 24°
Celsius (50° to 75° Fahrenheit). Recommended
maximum hot water temperature is 51° Celsius (125°
Fahrenheit). Warm water is a mixture of hot and cold
water. (Warm water temperature is dependent upon the
water temperature and the pressure of both the hot and
cold water supply lines.)
WARNING
To prevent personal injury, avoid contact
with inlet water temperatures higher than
51° Celsius (125° Fahrenheit) and hot
surfaces.
Pressure must be a minimum of 138 to a maximum of
827 kPa (20 to 120 psi) static pressure measured at the
faucet.
NOTE: Water pressure under 138 kPa (20 psi) will
cause an extended fill time in the washer.
Turn on the water supply faucets and flush the lines for
approximately two minutes to remove any foreign
materials that could clog the screens in the water
mixing valve. (This is especially important when
installing your washer in a newly constructed or
renovated building.)
Connecting Hoses
Insert rubber washers and filter screens (from
accessories bag) in water fill hose couplings (two
hoses supplied with washer). Connect fill hoses to
water supply faucets. Then connect the hoses to the
hot and cold valve connections at the rear of the
washer. Refer to Figure 4.
NOTE: If using hoses with metric coupling,
connect the BLACK colored hose coupling end of
the fill hoses (with filter screens) to the water
supply faucets. Then connect end of hoses with the
brass colored hose couplings to the hot and cold
water mixing valve connections at rear of washer.
Thread hose couplings onto valve connections finger
tight. Then turn 1/4 turn with pliers.
IMPORTANT: DO NOT cross thread or
overtighten couplings.
201940
W750
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
1
COLD
HOT
2
8
7
1 Filter Screen (Screen must be facing
outward)
2 Fill Hose
3 Rubber Washer (Plain)
4 Cold Water Connection
5 Hot Water Connection
6 Install this end of hose to valve connections
at rear of washer.
7 Install this end of hose to water supply
faucet. (Black colored coupling for metric)
8 Faucet
Figure 4
IMPORTANT: Hoses and other natural rubber
parts deteriorate after extended use. Hoses may
develop cracks, blisters or material wear from the
temperature and constant high pressure they are
subjected to.
All hoses should be checked on a monthly basis for
any visible signs of deterioration. Any hose showing
the signs of deterioration listed above should be
replaced immediately. All hoses should be replaced
every five years.
IMPORTANT: Turn off water supply faucets after
check-out and demonstration. Owner should turn
off water supply whenever there will be an
extended period of non-use.
NOTE: Longer fill hoses are available (as optional
equipment at extra cost) if the hoses (supplied with
the washer) are not long enough for the
installation. Order hoses as follows:
No. 20617 Fill Hose 2.44 m (8 feet)
No. 20618 Fill Hose 3.05 m (10 feet)
Installation
4
3
C
H
5
6
TLW1988N
TLW1988N
9