Vending; Meter Case; Slide Extension Assembly - Models Through Serial No. 1211 - Alliance Laundry Systems W446I Manuel D'installation

Vending

Meter Case

The factory mounted coin meter case does not include
the service door lock, coin slide, coin drawer, coin
drawer lock or keys. These parts must be ordered (at
extra cost) according to the purchaser's requirements
direct from the manufacturer of your choice.
NOTE: You have the option of using a screw type
lock or a 1/4 turn lock on the meter case service
door. If you choose to use a screw lock, then the
special bracket (located inside the meter case) must
be used. DO NOT use the special bracket if a
1/4 turn lock is used.
Coin Drawer Security – For additional security, drill
out the two pilot holes on each side of the front of the
meter case to 6.4 or 7.9 mm (1/4 or 5/16 inch) holes
and install a bicycle lock through these holes.
NOTE: A 20.32 cm (8 in.) coin drawer is required
for coin operated electronic control models.
Slide Extension Assembly – Models
through Serial No. 1211
(Coin Slide Models Only)
1. Remove slide extension parts from parts
accessories bag included in unit.
2. If installing a Greenwald coin slide, position
extension lever (to be installed on extension
bracket) with arm that has one star facing down.
Refer to Figure 13.
Greenwald
Coin Slide
One Star
Figure 13
3. If installing a Monarch or ESD coin slide,
position lever with arm that has two stars facing
down. Refer to Figure 13.
201940
Monarch or
ESD Coin Slide
Two Stars
TLW2088N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
4. Install extension lever with rounded corner facing
away from extension bracket using bolt, one or
two flat washers (shims) (use number of washers
included in kit) and nut. Refer to Figure 14. Make
sure washers are flat against bracket.
Bolt
Spring
Loops
Extension Bracket
Star(s) Facing Down
Figure 14
5. Torque nut between 2 and 2.26 Nm (18 and 20
inch-pounds), or tighten nut firmly.
6. Install extension spring in bracket hole and hole in
upper arm of lever. Refer to Figure 14.
7. Bend loops closed after installation.
8. Check to make sure the lever swings freely.
Installing Extension Onto Coin Slide:
Option 1
1. Install slide extension onto top of coin slide using
two remaining screws and lockwashers. Refer to
Figure 15.
Lockwashers
Coin Slide
Figure 15
2. Insert coins and partially extend coin slide.
Installation
One or Two
Flat Washers (Shims)
Rounded Corner
Nut
Extension Lever
TLW2089N
TLW2089N
Attaching
Screws
Slide
Extension
TLW1564K
15