Alliance Laundry Systems W446I Manuel D'installation page 21

3. Tilt control panel forward and lay on a protective
pad to prevent scratching of cabinet top.
4. Insert Phillips head screw down through double
"D" hole in left rear corner of cabinet top (inside
control hood) until it engages retainer nut located
on left rear corner gusset of cabinet.
5. Finger tighten screw.
IMPORTANT: Do not use a power driver to tighten
screw. Torque of a power driver could over-tighten
screw causing damage to cabinet assembly.
6. Secure control panel to control hood using two
No. 8 tamper-resistant screws, Part No. 35528.
201940
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
7. Remove two screws holding front panel to base
of washer and install two No. 12 tamper-resistant
screws, Part No. 35527.
1
3
1 35528 No. 8 Screws
2 Double "D" Hole
3 35527 No. 12 Screws
Figure 23
Installation
2
W276I
W276I
19