Alliance Laundry Systems W446I Manuel D'installation page 32

Troubleshooting
Washer Symptom
Won't Drain
Water Leaks
Is Noisy
Load is too Wet
Wrong Water
Temperature
30
Make sure drain hose is not kinked or twisted.

Make sure drain hose is not clogged.

Make sure drain receptacle is not clogged.

Refer to the Installation section to make sure that the drain hose has been properly

installed.
Check that fill hoses are properly installed on the faucets and the washer's water mixing

valve.
Replace the fill hoses every five years.

Make sure drain receptacle is not clogged.

Check laundry room plumbing.

Laundry load may be oversudsing or overloaded. Use less detergent (or low-sudsing

detergent) and proper load sizes.
Wash load may be unbalanced. Open lid and redistribute the load.

Make sure washer is level. Uneven leveling can cause vibration.

A newly installed washer may make a knocking sound if the machine has been in storage.

The belt may have settled. Run washer through 4-5 cycles to loosen belt. Washer
operation will not be affected.
Wash load may be unbalanced. Open lid and redistribute the load.

Load is too small. Add items to make full load.

Make sure that the controls are properly set.

Check fill hoses. Make sure hot faucet hose is connected to hot mixing valve (indicated

with "H" on the valve bracket) and cold faucet is connected to cold mixing valve
(indicated with "C" on the valve bracket).
Make sure laundry room water heater is adjusted properly.

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Possible Cause/Solution
201940