Repacking - Mustang Survival MD6254 Guide D'utilisation

REPACKING

Repacking should only be done after re-arming and completely
deflating the PFD (see Re-arming, p. 19, and Deflating, p. 17).
1. First pack any accessory devices such as crotch straps, lifting
loop, spray hood. See below instructions in this section
2. At chin level of the PFD, tuck in material on each side of
chin (Fig. 25)
3. Zip each chin side closed, by running each zipper all the way
down to the zipper stop and then back up (Fig. 26 and Fig. 27)
4. Tuck the tabs over each zipper stop into the slots on the inside of
the PFD (where the PFD would rest against your chest) (Fig. 28)
5. Fold in the bottom pleat (or gusset), making sure to align Velcro™
strips and close (Fig. 29).
6. Fold in the sides, making sure to tuck in reflective material and
oral tube on (wearer's) left side and whistle on the right side
(Fig. 30)
7. Zip each side closed, by running each zipper all the way down to
the zipper stop and then back up (Fig. 31 – Fig. 33)
8. Close Velcro™ tabs over each zipper stop. This will prevent
unintended break-out of the zippers (Fig. 33)
FIGURE 25
FIGURE 27
24
MUSTANG SURVIVAL/ OWNER'S MANUAL
FIGURE 26
FIGURE 28