Attaching To Tether - Mustang Survival MD6254 Guide D'utilisation

INSTRUCTIONS FOR USE OF SAILING HARNESS (CONT'D)

ATTACHING TO TETHER

• When you're attached to the boat, use a tether of less than 2m
(6 feet, 6 inches) in length with quick-release under-load hardware
(Fig. 38)
• Clip tether into the webbing attachment point at bottom front of
the PFD
• Tug on tether to ensure it is securely attached to the PFD
Webbing
attachment point
Tether webbing
FIGURE 38
SAILING HARNESS WARNING
Using a sailing harness to prevent falls overboard presents several
risks. In case of capsizing or sinking, the boat may take you down.
As such, use only a proper tether with proper attachment point
(described on previous page).
This harness has not been designed for fall arrest, lifting, or climbing
and should not be relied upon in any of these instances.
Design and testing of this harness is governed by ISO12401 standards
– which are separate from Transport Canada approval of the PFD.
28
MUSTANG SURVIVAL/ OWNER'S MANUAL
Quick release
lanyard