Mustang Survival MD6254 Guide D'utilisation page 21

7. Squeeze the clear O-ring to
elongate it – until it looks
more like an oval. This will
give you enough room to pull
the inflator body and cylinder
out of your PFD.
8. Gripping the inflator body,
pull it and the cylinder out
through the clear O-ring in
the PFD. (Fig. 18). Discard
the used inflator body and
cylinder (Fig. 19).
PUTTING IN NEW INFLATION
EQUIPMENT
9. Get the new inflator body
and cylinder from the
re-arm kit - this is the black
circular disc and the cylinder
attached to it.
10. Make sure the indicator on
the inflator body is green. If
indicator is not green, you
will need a new inflator body
and cylinder before you can
re-arm.
11. Gripping the inflator body,
insert the cylinder through
the clear O-ring – aligning
it with the screen print on the covering material (Fig. 20). The
inflator body will remain visible.
12. Line up the clear O-ring on the grooves of the inflator body so
that O-ring and inflator body are in even contact all the way
around.
13. Get new (black and yellow) inflator cap from re-arm kit and
check its face for:
– a green indicator
– a valid expiration date
– If indicator is not green or the expiry date has already passed,
you will need a new inflator cap before you can re-arm.
FIGURE 17
Red
Indicator
FIGURE 18
Trash
FIGURE 19
Inflator
Body
Sealing
Ring
Red
Indicator
21