General Description - GYS GYSFLASH 15.24 PL-E Mode D'emploi

Translation of the original instructions

GENERAL DESCRIPTION

GYSFLASH 15.24 PL-E is an on-board charger designed for charging traction batteries used in forklifts or floor
scrubbers, utility batteries found in the navy, lorries or buses and batteries for electromobility transport vehicles
(bicycles, scooters, golf cars,...). Suitable to charge most of lead (Liquid/Gel, AGM) and Lithium batteries (LiFePO5,
Lithium-Ion...).
This charger is perfectly suited for charging and maintenance of:
- 24 V Liquid/Gel-AGM lead batteries (12 cells in series) from 30 Ah to 240 Ah.
- LFP batteries 24V (8 elements in series) from 15 Ah to 240 Ah.
- 24 V Li-ion batteries (7 cells in series) from 15 Ah to 240 Ah.
CONNECTION AND WIRING
1 2
A
L N
1 2
B
S
▪ Crimp the appropriate wiring sleeves 1 for the cross-section of each cable.
▪ Screw the sleeves onto the connector following the connection diagrams for connectors A and B (above).
▪ Clip the connectors into their sockets on the board.
▪ Pass the cables through the rubber cable glands 2 and plug them into the sheet metal.
▪ Attach the flanges 3 in such a way that the wired parts inside the housing are never under tension
10
(screws M3x20 - TORX 10).
GYSFLASH 15.24 PL-E
A
1
3
Connections
230~ MAINS CONNECTION
1. LIVE
2. NEUTRAL
3 4
3. Not Connected
4. EARTH
Order No. Connector Würth Electronik
691344510004
24 V BATTERY CONNECTION
1. SIGNAL mains presence (+24/50mA)
2. NEGATIVE CONNECTION -24 V
3
3. POSITIVE CONNECTION +24 V
Order No. Connector Würth Electronik
691344510003
B
1
3
2
EN
Wiring
Type Section
mini :
3G0.75 mm²
H05RN-F
or equivalent
maxi :
3G2.5 mm²
Battery (2/3)
2.5 mm²
or
AWG14
H01V-K
or equivalent
Signal (1)
maxi 2.5 mm²