Siemens 6GK1970–5CA20–0AA2 Instructions De Montage page 359

6ZB5530–3AC30–0BA1
Screw M6 x 16
Mounting bracket 2
Installation site
Installing the ILM with mounting bracket
side view
Figure 15: Side View of a PROFIBUS ILM Installed With Mounting Brackets
By installing angle 1 in different holes on the mounting surface, it is possible to turn the PROFIBUS ILM
through the vertical axis, however the adjustment is not continuous.
By loosening the M6 securing bolts, the PROFIBUS ILM can be adjusted continuously to align it to the partner
station in the horizontal axis. To add greater stability, it is advisable to use toothed washers with the bolts.
It is also advisable to install the module at the edge of the mounting surface so that the cables lead to and from
the module unhindered and to make sure that there is no reflection of the sender to its own receiver caused by
the installation site itself.
Alignment
by turning
Mounting bracket 1
35
Infrared Link Modul (ILM)
ILM
Threaded cable inlets
Cables for
PROFIBUS,
power supply and
signaling contact
Copyright  by Siemens