General Information; About These Instructions; Copyright; Subject To Change - Wilo EMU FA Notice De Montage Et De Mise En Service

en
1

General information

1.1

About these instructions

1.2

Copyright

1.3

Subject to change

1.4

Warranty

2

Safety

2.1 Identification of safety instruc-
tions
36
General information
These installation and operating instructions are an integral part of the product. Read
these instructions before commencing work and keep them in an accessible place at all
times. Strict adherence to these instructions is a requirement for intended use and cor-
rectly operating the product. All specifications and markings on the product must be
observed.
The language of the original operating instructions is German. All other languages of
these instructions are translations of the original operating instructions.
These installation and operating instructions have been copyrighted by the manufac-
turer. The contents, of whatever type, may not be reproduced or distributed, or used for
purposes of competition and shared with others.
The manufacturer reserves the right to make technical modifications to the product or
individual components. The illustrations used may differ from the original and are in-
tended as an example representation of the product.
The specifications in the current "General Terms and Conditions" apply to the warranty
and the warranty period. These can be found at www.wilo.com/legal
Any deviations must be contractually agreed and shall then be given priority.
Claim to warranty
If the following points are complied with, the manufacturer is obligated to rectify every
qualitative or constructive flaw:
▪ The defects are reported in writing to the manufacturer within the warranty period.
▪ Application according to intended use.
▪ All monitoring devices are connected and tested before commissioning.
Exclusion of liability
Exclusion from liability excludes all liability for personal injury, material damage or fin-
ancial losses. This exclusion ensues as soon as one of the following applies:
▪ Inadequate configuration due to inadequate or incorrect instructions by the operator or
the client
▪ Non-compliance with installation and operating instructions
▪ Improper use
▪ Incorrect storage or transport
▪ Incorrect installation or dismantling
▪ Insufficient maintenance
▪ Unauthorised repairs
▪ Inadequate construction site
▪ Chemical, electrical or electro-chemical influences
▪ Wear
This chapter contains basic information which must be adhered to during the individual
phases of the life cycle. Failure to follow the installation and operating instructions will
result in injuries to persons, damage to the environment and the device and result in the
loss of any claims for damages. Failure to follow the instructions can result in the fol-
lowing risks:
▪ Injury to persons from electrical, mechanical and bacteriological factors as well as elec-
tromagnetic fields
▪ Environmental damage from leakage of hazardous substances
▪ Property damage
▪ Failure of important functions of the product
Additionally, the instructions and safety instructions in the other chapters must be
observed!
These installation and operating instructions set out safety instructions for preventing
personal injury and damage to property. These safety instructions are shown differ-
ently:
▪ Safety instructions relating to personal injury start with a signal word, are preceded by
a corresponding symbol and are shaded in grey.
WILO SE 2018-02