Winterizing The Installation - BWT TM CS Mode D'emploi

5.

WINTERIZING THE INSTALLATION

• Backwash the filter,
• Treat the pool water with winterizing products.
• Run the pump with the mulitport valve set to «circulation» to homogenise the concentration of these
chemicals in the pool water.
• Stop the pump,
• Turn the mulitport valve to the «DRAIN» position,
• Open the valve on the waste line,
• Close the skimmer and vacuum point valves,
• Turn the motor on,
• Lower the water level by about 30 cm,
• Next, drain the filter by unscrewing the drain plug at the base,
• Close all the valves,
• Unscrew the drain plugs on the motor,
• Cut power to the control panel,
• Store the motor somewhere dry.
• Put the 6-way multi-port valve to the «HIVER» (WINTER) position (see below).
22/48
2021/01 - Indice de révision : I - Code : 26690 CONSTRUCTION & RÉNOVATION