Filter Pressure Rises Out Of The Green Zone - BWT TM CS Mode D'emploi

• Clean out the skimmers.
• Put the 6-way multiport valve to «FILTRATION»,
• Open the suction valves A, B, C, D (skimmers, main drain) and the return fitting valve E,
• Restart the pump,
• Purge air from the filter.
This operation should be carried out each time the pool is vacuumed using a brush on a suction line, and
at least once a week.
4.1.2 Filter pressure rises out of the green zone
Back wash the filter
• Stop the filter,
• Check the pre-filter for debris. (If there is a build-up of dirt clean it out as described above),
• Put the 6-way multiport valve to the «WASH» position,
• Open the 1/4 turn valve (F) on the outflow pipe,
• Turn the motor on,
• Monitor the water colour through the turbidity sight glass on the 6-way multiport valve.
CAUTION
Cleaning will start after a few seconds. (The water becomes very cloudy).
• As soon as the water in the turbidity sight glass becomes clear, stop the pump,
• Put the 6-way multiport valve to the «RINSE» position,
• Turn the pump on for about 20 to 30 seconds. The purpose of this step is to evacuate any remaining
impurities and settle the sand,
• Stop the pump,
• Put the 6-way multiport valve to the «FILTRATION» position,
• Restart the pump,
• Close the 1/4 turn valve (F) on the waste line.
After back washing, the black hand on the pressure gauge should be realigned with the blue hand, that is
the pressure reading should return to the nominal pressure
In the event that the pressure indicated by the pressure gauge does not drop after back washing the filter
once (or even twice) contact your installer.
CONSTRUCTION & RÉNOVATION 2021/01 - Indice de révision : I - Code : 26690
21/48