Würth 1952 003 450 Mode D'emploi page 17

adjustment of the clutch engagement system,
always refer to the instructions provided by the
parent company/manufacturer.
DUAL CLUTCH ASSEMBLY
- Fit the new clutch unit on the main outer shaft.
Make sure the main outer shaft properly couples with the gear
teeth of the clutch disc (K2).
Warning: always refer to the instructions
provided by the parent company/manufacturer.
D
- Place thrust bushing
unit bearing.
- Assemble cross member
casing.
Make sure the cross member and the thrust bushing work
perpendicular to the clutch casing bell.
- Turn the cross member's drive screw and keep pressing the thrust
bushing until you can see the safety ring's seat.
Warning: lubricate the drive screw and press it
only as much as necessary to avoid damage to
the main outer shaft support and the gearbox.
- Remove both the cross member and the thrust bushing.
- Fit the new safety ring.
Refer to the instructions provided by the parent
company/manufacturer for the correct assembly steps
of the new safety ring.
on the internal central ring of the clutch
A
securing it properly to the clutch
17