Satinglide™ Roll-Out Extension Rack; Meat Thermometer - KitchenAid KDRU707 Guide D'utilisation Et D'entretien

BAKEWARE
To cook food evenly, hot air must be able to circulate. For
traditional cooking, allow 2" (5 cm) of space around bakeware
and oven walls. For convection cooking, allow 1" (2.5 cm) of
space around bakeware and oven walls. Use the following chart
as a guide.
NUMBER POSITION ON RACK
OF PAN(S)
1 Center of rack.
2 Side by side or slightly staggered.
3 or 4 Placement that gives best result. Make sure that
no bakeware piece is directly over another.
SatinGlide™ Roll-Out Extension Rack
The SatinGlide™ roll-out extension rack allows easy access to
position and remove food in the oven. It can be used in rack
positions 1 through 4. The SatinGlide™ roll-out extension rack
will not fit in position 5.
Open Position
A
A. SatinGlide™ Roll-out extension rack
B. Sliding shelf
Closed and Engaged Position
A
A. SatinGlide™ Roll-out extension rack
B. Sliding shelf
To Remove SatinGlide™ Roll-Out Extension Rack:
1. Slide the rack in completely so that it is closed and engaged
with the sliding shelf.
2. Using 2 hands, lift up on the front edge of the rack and the
sliding shelf together. Slowly push both to the back wall of the
oven so the front edge of the sliding shelf sits on the rack
guide located on the sides of the oven.
B
B
The front edge of the rack and the sliding shelf should be
higher than the back edge.
A
B
A. Sliding shelf
B. Rack guide
C. SatinGlide™ Roll-out extension rack
3. Using 2 hands, lift up the back of the rack and the sliding
shelf so that the back and front are level on the rack guide.
4. Pull the rack and the sliding shelf out.
To Replace SatinGlide™ Roll-out Extension Rack
1. Using 2 hands, grasp the front of the closed rack and the
sliding shelf. Place the closed rack and the sliding shelf on
the rack guide.
2. Slowly push the rack and the sliding shelf to the back of the
oven until the back edge of the sliding shelf drops.
3. Pull the rack and the sliding shelf slightly forward until the
front edge drops and the sliding shelf is on the rack guide.
To avoid damage to the sliding shelves, do not place more than
25 lbs (11.4 kg) on the rack.
Do not clean the SatinGlide™ roll-out extension rack in a
dishwasher. It may remove the rack's lubricant and affect its
ability to slide.
See the "General Cleaning" section for more information.

Meat Thermometer

When not using the supplied temperature probe, use a meat
thermometer to determine whether meat, poultry and fish, are
cooked to the desired degree of doneness. The internal
temperature, not appearance, should be used to determine
doneness. A meat thermometer is not supplied with this
appliance. Follow manufacturer's directions for using a meat
thermometer.
C
21