Satinglide™ Roll-Out Extension Rack - KitchenAid KOSE500ESS Guide D'utilisateur

Convection Cooking
OVEN SETTING NUMBER OF
RACKS USED
Rapid Preheat Bake 1
Rapid Preheat 1
Convection Bake
Convection Bake 1
Convection Bake 2
Convection Bake 3
Convection Roast 1
Convection Broil 1
Baking Cakes on 2 Racks
For best results when baking cakes on 2 racks, use the Bake
function and flat racks in positions 2 and 5. Place the cakes on the
racks as shown. Keep at least 2 inches of space between the front
of the racks and the front of the cakes.
Baking Cookies on 2 Racks
For best results when baking cookies on 2 racks, use the Convect
Bake function and place flat racks in positions 2 and 5.
Bakeware
To cook food evenly, hot air must be able to circulate. For best
results, allow 2" (5 cm) of space around bakeware and oven walls.
Use the following chart as a guide.
NUMBER POSITION ON RACK
OF PAN(S)
1 Center of rack.
2 Side by side or slightly staggered.
3 or 4 See the rack position graphics in this section for
pan placement recommendations.
SatinGlide™ Roll-Out Extension Rack
RACK
The SatinGlide™ roll-out extension rack allows easy access to
POSITION(S)
position and remove food in the oven. It can be used in rack
3
positions 1 through 6.
Open Position
3
1, 2 or 3
2 and 5
1, 3 and 5
1 or 2
4, 5 or 6
Closed and Engaged Position
To Remove SatinGlide™ Roll-Out Extension Rack:
1. Slide the rack in completely so that it is closed and engaged
2. Using 2 hands, lift up on the front edge of the rack and push
3. Pull the rack and the sliding shelf out.
10
A
A. SatinGlide™ roll-out extension rack
B. Sliding shelf
A
A. SatinGlide™ roll-out extension rack
B. Sliding shelf
with the sliding shelf.
the sliding shelf to the back wall of the oven so that the front
edge of the sliding shelf sits on the rack guides. The front
edge of the rack and the sliding shelf should be higher than
the back edge.
A
B
A. Sliding shelf
B. Rack guide
C. SatinGlide™ roll-out extension rack
B
B
C