Instrument And Control Functions; Right Handlebar Switch - Yamaha FJR1300AP 2008 Supplément Au Manuel

INSTRUMENT AND CONTROL FUNCTIONS

-2-
INSTRUMENT AND
CONTROL FUNCTIONS

RIGHT HANDLEBAR SWITCH

Engine stop switch
Patrol switch
Start switch
Hazard switch
ENGINE STOP SWITCH
Set this switch to " " before starting the engine.
Set this switch to " " to stop the engine in case
of an emergency, such as when the motorcycle
overturns or when the throttle cable is stuck.
PATROL SWITCH
This switch activates the siren or flashing lamp.
NOTE:
It is used when a siren or flashing lamp is installed.
OFF
This is for the flashing lamp.
This is for both siren and
flashing lamp.
START SWITCH
Push this switch to crank the engine with the starter.
HAZARD SWITCH
With the key in the "ON" or "P" position, use this
switch to turn on the hazard lights (simultaneous
flashing of all turn signal lights).
The hazard lights are used in case of an emer-
gency or to warn other drivers when your vehicle
is stopped where it might be a traffic hazard.
CAUTION:
Do not use the hazard lights for an extended
length of time with the engine not running, oth-
erwise the battery may discharge.