Rack Accessories; Adjustable Top Rack - Thermador DWHD410JFM Guide D'utilisation Et D'entretien

Rack Accessories

Adjustable Top Rack

The top rack can be raised or lowered to accommodate large items in either rack. Ensure the rack
is empty before moving (raising or lowering a loaded rack can lead to damaged dishes and possi-
ble injury from broken glass). See Figure 1.
Note: Before pushing the top rack into the dishwasher, ensure the rack height is the same
on both sides. If the height is not the same on both sides, the dishwasher door will not shut
and the top rack spray arm will not connect to the water inlet.
To lower the top rack:
Pull the empty top rack out of the dishwasher until it stops.
1
Press the adjustable top rack handles inward and let the rack drop gently.
2
To raise the top rack:
Pull the empty top rack out of the dishwasher until it stops.
1
Grasp the top of the rack above the handles and pull it upward until the handles lock the rack
2
into position (you do not need to press the handles in order to raise the rack).
Extra Tall Item Sprinkler
If an item is too tall to be placed in the bottom rack even with the top rack in the raised position,
remove the empty top rack by pulling it out of the dishwasher until it stops. Pull the front of the
rack upward and outward until the rollers are completely free of the roller guides.
Set the top rack aside. Push the roller guides back into the dishwasher. Insert the Extra Tall Item
Sprinkler into the top rack spray outlet and turn the sprinkler clockwise to lock into position. See
Figure 2.
Note: Keep the vent on the tub's right side clear by placing tall items such as plastic cutting
boards and tall baking sheets on the bottom rack's left side or center.
To avoid dishwasher damage, do not reinstall the top rack without removing the Extra Tall Item
Sprinkler.
Flip Tines
The racks consist of tines that can be folded down depending on what you may need to load in
the rack. To fold down, grasp the folding tine and release from notch. Push folding tine downward
to desired position as shown in Figure 3.
8
NOTICE
Figure 1
Figure 2
Do not
block vent
Figure 3