Side Mounting - Agilent Technologies TwisTorr Medium-TMP Mode D'emploi

17 Technical Information
TwisTorr Medium-TMP onboard Controller Installation

Side Mounting

The L-shaped bracket (P/N X3511-68003) is available as an option.
NOTE
See the following figure.
8
9
10 Place the bracket on the pump bottom (the hole on the bracket
11 Screw a little bit the three screws M6 in the holes on the pump
12 Rotate the bracket until the controller is on the chosen position;
13 Tighten the screws properly;
14 Turn the pump again;
15 Plug the line card and connect the pump cable to the pump;
16 Connect the mating connector with the jumper on the interlock
Figure 20 Side Mounting
174/181 TwisTorr Medium-TMP onboard Controller User Manual / 87-901-050-01 (B)
Place the L-shaped bracket on the controller, with the pump
cable toward the bracket, and fix it by means of the three socket
head screws M5, the washers and the nuts. The 6 holes on the
bracket allows to mount the controller with the rotation angle
that you like;
Turn the pump upside-down;
has the same diameter as the pump bottom flange);
bottom;
signal to start the pump.