Assembly Instructions; Fitting The Saw Chain And Blade; Tensioning The Saw Chain - Grizzly AKS 1820 T Lion-Set Traduction De La Notice D'utilisation Originale

Assembly instructions

Turn off the appliance and, before
doing any servicing, remove the
battery.
If the tubes of the device are not
fitted into each other or screwed
correctly, the device cannot be
switched on. A safety switch pre-
vents the operation!
Use only original parts.
Assemble device
1. Interlock the end of the hex-
agonal aluminium pipe of the
telescopic arm (10) and the end
of the arm below the cutting
head (7) up to the stop. Whilst
interlocking the two, ensure that
the nose (10a) of the hexagonal
aluminium pipe fits into the nut
(7a) at the end of the arm (see
small image).
2 Fasten both parts using the
screw sleeve (9).
Fitting the saw chain and
blade
Turn off the appliance and, before
doing any servicing, remove the
battery.
1. Loosen the blade fixing screws
(5) and remove the chain wheel
cover (6) (see small image).
2. Spread out the sawing chain (1)
in a loop in a way that the an-
gled cutting edges of the chain
links are aligned clockwise.
3. Place the sawing chain (1) into
the blade groove.
.
4. Turn the chain tensioner screw
(3) on the chain wheel cover (6)
in an anticlockwise direction until
the chain tensioner pin (33) is
located on the stop position.
5. To install, hold the blade (2)
tilted at an angle of approx.
45 degrees upward, and guide
the sawing chain (1) around the
chain wheel (34).
6. Place the blade (2) so that the
drill hole (31) in the blade (2) fits
the chain dowel pin (33)
7. Assemble the chain wheel cover
(6) with the blade attachment
screw (5).
8. Tighten the blade attachment
screw (5) with light hand force
only because the sawing chain
(1) must still be tightened.
Ensure that chain tensioning pin
(33) is positioned in hole (31) on
the blade (2). The pin must be com-
pletely inserted into the hole.

Tensioning the saw chain

Turn off the appliance and, before
doing any servicing, remove the
battery.
The tension of saw chain (1) is important
both for your safety and for the function of
the cordless pruner. A correctly tensioned
saw chain will increase the lifetime of your
equipment.
Check the chain tension before
each use of the cordless pruner.
• Saw chain (1) is correctly ten-
sioned if it can be pulled around
blade 2 by hand (wearing
gloves) without sagging.
GB
61