Maintenance - MC Crypt MYLED-026A Notice D'emploi

13. Maintenance

Regularly check the technical safety of the light effect, e.g. for damage to the mains cable or the casing.
If you have reason to believe that the device can no longer be operated safely, disconnect it immediately and make
sure it is not unintentionally operated. Pull the mains plug from the mains socket!
It can be assumed that safe operation is no longer possible if:
• the device is visibly damaged
• the device no longer works
• the device was stored under unfavourable conditions for an extended period of time or
• after exposure to extraordinary stress caused by transport
Before cleaning the effect beamer, observe the following safety instructions:
Disconnect the device from all voltage sources before cleaning.
The device contains no parts that require servicing by the user. Therefore, never open the
device.
Only qualified experts familiar with the hazards involved and the relevant regulations must
perform repairs.
Fuse Replacement
If you have to replace the fuse, ensure that you only use fuses of the specified type and rated current (see "Technical
Data") as a replacement.
Never repair fuses or bridge the fuse holder.
• After mains disconnection (pull the mains plug!), pull the low-voltage plug from the mains connection
POWER IN at the device. Lever out the fuse holder at the mains connection POWER IN with the defective fuse.
• Remove the defective fuse and replace it with a fuse of the same type.
• Now carefully re-insert the fuse holder with the new fuse.
• Only then connect the mains line to the device again and plug into a mains socket.
The outside of the effect light should only be cleaned with a soft, dry cloth or brush.
Never use any aggressive cleaning agents or chemical solutions as these may damage the surface of the casing.
36