Reely Sparrow Notice D'emploi page 45

If the rudder and elevator are not aligned precisely in the middle position of the trim on the transmitter, the bend in the
linkage wire may be used to precisely align the rudder or elevator (as shown in figure 11, item 3). The bend can be
compressed or expanded as required. Use small long-nose pliers or tweezers and work with the required dexterity.
Figure 11, item 1 (rudder) or figure 11, item 2 (elevator) shows the linkage wire connected at the outside
of the rudder horn. Experienced pilots who would like to increase deflection at the rudder or elevator may
connect the linkage wires attached to the outside at the inner position (see arrow). Use long-nosed pliers for
this and proceed with care to avoid damage to the model.
Figure 11
45