Meister WS750-125M Traduction Du Manuel D'utilisation Original page 55

ing parts. Loose clothes, jewellery or
long hair can be caught in moving
parts.
g If devices are provided for the con­
nection of dust extraction and col­
lection facilities, ensure these are
connected and properly used. Use
of these devices can reduce dust
related hazards.
4 Power tool use and care
a Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
b Do not use the power tool if the
switch does not turn it on and of.
Any power tool that cannot be con-
trolled with the switch is dangerous
and must be repaired.
c Disconnect the plug from the
power source before making any
adjustments, changing accessories,
or storing power tools. Such preven-
tive safety measures reduce the risk of
starting the power tool accidentally.
d Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to oper­
ate the power tool. Power tools are
dangerous in the hands of untrained
users.
e Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may afect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
5405130-Winkelschleifer-man.indd 55 5405130-Winkelschleifer-man.indd 55
f Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are
less likely to bind and are easier to
control.
g Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
5 Service
a Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This
will ensure that the safety of the
power tool is maintained.
II. Safety notes for all applications
General warnings with regard to abra-
sive cutting and roughing:
a This electrical tool is to be used as
a grinder and cutting device. Pay
attention to all of the warning
notes, instructions, diagrams and
data you receive with the unit. If you
do not observe the following instruc-
tions, it may lead to electrical shock,
fire and/or serious injuries.
b This electrical tool is not suitable
for sandpaper sanding, working
with wire brushes, polishing. Uses
for which the tool is not designed
may cause risks and injury.
c Do not use accessories that have
not been designed and recom­
mended by the manufacturer for
use with this electrical tool. Just
because you can affix an accessory
55
27.10.20 12:18 27.10.20 12:18