Ventilation; Volumetric Flow Measurement (Nominal Ventila- Tion); Volumetric Flow Of Ventilation Level; Night-Time Cooling/Flush Mode - Maico RLS T2 WS Notice De Montage Et Mode D'emploi

9 Unit settings menu

9.3 Ventilation

Volumetric flow measurement (nominal ventila-
tion)
Volumetric flow Ventilation level Reduced ventila-
tion
Volumetric flow Ventilation level Nominal ventila-
tion
Volumetric flow Ventilation level Intensive ventila-
tion
EA/SA (exhaust air/supply air) adjustment Re-
duced ventilation
EA/SA adjustment Nominal ventilation
EA/SA adjustment Intensive ventilation

Night-time cooling/flush mode

Air volume Volumetric flow compensation (opera-
tion with exhaust air system)
Unit filter
Filter service life of unit filter
Filter change of unit filter
External filter
Filter service life of external filter
Filter change of external filter
Room filter
Filter service life of room filter
Filter change of room filter

Duration of ventilation level

Motion detector overrun time

Supply and exhaust air valves are set during ini-
tial commissioning. Open or close them to set the
values specified by the planning office.
9.3.1 Volumetric flow measurement (nominal
ventilation)
Volumetric flow measurement (nominal ventila-
tion)
Parameters: Volumetric flow measurement (nom-
inal ventilation)
Set value: On / Off
After activating the volumetric flow measurement,
the fans are run for a maximum of 3 hours in
nominal ventilation. This allows the supply and
exhaust air volumetric flows in the building to be
calibrated without the air volumes being changed
by sensor values. The function switches off auto-
matically after 3 hours. The function can be
switched off manually.
40

9.3.2 Volumetric flow of ventilation level

Reduced ventilation RV (in m³/h)
Type Min.
WS 310 / WS 80
320 ..
WS 410 / WS 80
470 ..
WS 170 40
WS 160 Flat 40
WS 300 Flat 80
Trio 40
Nominal ventilation NV (in m³/h)
Type Min.
WS 310 / WS 80
320 ..
WS 410 / WS 80
470 ..
WS 170 40
WS 160 Flat 40
WS 300 Flat 80
Trio 40
Intensive ventilation IV (in m³/h)
Type Min.
WS 310 / WS 80
320 ..
WS 410 / WS 80
470 ..
WS 170 40
WS 160 Flat 40
WS 300 Flat 80
Trio 40
The volumetric flow setting applies to both fans.
With humidity protection ventilation, the fans run
in intermittent operation. We recommend setting
the volumetric flow for NV first.
The RV and IV volumetric flows are set automat-
ically by the control on the basis of the NV refer-
ence value 1/3 less than (RV) and 1/3 greater
than (IV).
Example WS 310/410, WS 320/470, WS 300
Flat:
NV 150 → RV 100 → IV 200
Factory Max.
set
120 320
160 490
60 160
60 160
100 300
60 120
Factory Max.
set
180 320
240 490
90 160
90 160
150 300
90 120
Factory Max.
set
240 320
320 490
120 160
120 160
200 300
120 120