Mounting The Device; Wiring Cable Under The Device - Haag-Streit LENSTAR LS 900 Mode D'emploi

. Mounting the device

.. Lifting the device
To lift or reposition the device (short distances only):
a) Grasp device from behind with one hand on the column and lift
(Figure 41).
b) With the second hand, support under the cross-slide
(Figure 42).

.. Wiring cable under the device

The device can be invisibly wired by passing cables through the
cross-slide and using the cable channel underneath. To do this, you
need either the Haag-Streit instrument table HSM901 with table-top
biometer, or an aperture in the table-top used.
• Remove cable cover (Figure 43)
• Expose USB and supply cables (table aperture, Figure 44)
• Push supply cable through aperture in base of cross-slide until
the cable emerges from the upper front aperture (Figure 45)
• Push USB cable through the same aperture in the cross-slide
(Figure 45)
• Plug both cables into the corresponding boxes and fix with the
tension compensator (Figure 46)
• Replace cable cover (Figure 47)
1500.7220055.04030 © Haag-Streit AG, CH-3098 Koeniz, Switzerland