Cables At Side (Option); Computer Connection; Software - Haag-Streit LENSTAR LS 900 Mode D'emploi

Biomètre olcr (optique de faible cohérence reflectométrique)

Masquer les pouces Voir aussi pour LENSTAR LS 900:

Table des Matières

.. Device connection, cables at side (Option)

• Remove cable cover (Figure 48)

• Expose USB and supply cables (left or right aperture on rail

cover)

• With a knife, cut towards the snap-off point provided on the left

or right of the cable cover (Figure 49)

• Carefully use fingers to snap off the cut part (Figure 50)

• Insert both cables in the appropriate box and fix with the tension

compensator.

• Join both cables together with spiral cable and attach firmly using

the cable channel on the rail cover (Figure 51)

• Replace cable cover

• Connect the LS 900

to the PC with the enclosed USB2.0 cable.

Use of the 2 m cable supplied with delivery is recommended.

BEWARE

The USB cable should not exceed 5 m in length,

otherwise impairment of device function must

be expected.

• Insert mains cable. Integral mains components work with the vol-

tages specified under section 7.1 'Technical data'. It is not necessary

to select the voltage on the device.

• If an instrument table has been supplied, the power supply of the

LS 900

can beconnected to the Switchbox SB01 (left drawer). Use the

manual enclosed to the switchbox and the instrument table.

Install software in accordance with separately described 'Software

Installation'.

1500.7220055.04030

Table des Matières