Mounting Canopy Hood Above An Island; Technical Specifications - Pelgrim LSK Série Notice D'utilisation

If the recirculation system is to be applied,
mount the T-piece (C) instead of a duct.
Fit the short cylinder to the mounting
bracket (B) and pull the long cylinder to the
top of the canopy hood.
Screw the chimney in place from the inside
of the canopy hood (remove filters).
Electrical connection
Connect the two lamp connectors to the
motor connector.
Connect the connector of the slide box to
the remaining motor connector.
Make sure the supply voltage ratings
correspond with those stated on the
appliance data plate.
Attention: If you want to make a fixed
connection, ensure that a multi-pole switch
with a distance between contacts of 3 mm
is installed in the supply cable.
The appliance must be connected to a
system equipped with earth or ground
plate.
Colour of the wires:
- green/yellow = earth
- blue = phase N
- brown = phase L

Technical specifications

Type LSK 950/980/990/990G/991995
Power 230 V - 50 Hz X
Nominal capacity W 250
Motor W 210
Lighting W 2xhalo 20
Mounting the canopy hood above
an island
See fig. 9. Make sure that the ceiling is
suitable for the suspension of the construction
chimney.
First determine the position and distance
with regard to the chimney. Make a 140
mm hole in the ceiling for the duct.
If the opening for the flex (bottom of the
chimney construction 1) is pointed towards
you, then the control switches will be to
your right.
Drill 4 10 mm holes for the plugs and screw
the chimney against the ceiling.
Press the 2 flange halves (2) firmly
together, so that the snap connection is
made and then screw the assembled flange
(2) to the canopy hood.
Slide the inner cylinder (3) over the
chimney construction up to the ceiling and
fix it with 2 screws (4). Then slide the outer
cylinder (5) on.
Fix the canopy hood to the chimney
construction with the 4 M6 screws (6).
Make the electrical connection and
observe the flex opening (1).
Now fix the outer cylinder (5) to the cooker
hood with 2 screws, this is done from the
inside of the cooker hood.
SKE 900 SKE 925
X X
240 290
210 210
2xTL 15 4xhalo 20