Mounting The Cooker Hood - Pelgrim ISW670RVS Mode D'emploi

5 Installation

5.2 Mounting the cooker hood

• Remove the grease filter.
• Make a hole in the mounting panel:
680 x 371 mm.
Take care that there is at least 60 mm
of material around the hole in order
to avoid any damage during the
following installation.
• Adjust the position of the lateral
springs making attention of the
thickness of the material you are
using to fix the unit.
• Insert the unit from below (see fig. A).
The springs, previously adjusted, are
strong enough to keep the product
fixed for a while.
• Insert the four blocking levers into the
holes (see fig. B).
• Fix the blocking levers using the screws
(see fig. C).
Attention! Do not tighten the screws
too much otherwise the planarity of the
frame could be compromised.
• Mount the grease filter again.
41