Changing The Light Bulbs; Cleaning; Ordering Carbon Filters - Pelgrim LSK Série Notice D'utilisation

Fitting the carbon filter
Place the frame of the start set once. Place
the carbon filter (C, see fig. 5) in the frame in
the way that is shown and fit the filter panels
in the hood. After cleaning the filter panel or
replacing the carbon filter the character G or
C on the display will dissapear by pressing
either switch (3) or switch (4) for more than 10
seconds.

Changing the light bulbs

Halogen lighting
See fig. 6.
Slide the cath (1) in the direction indicated
and fold the cover (2) downwards. Pull the
bulb (3) in the direction of the arrow and out of
the holder, then fit the new bulb.
Strip lighting
See fig. 7.
Remove the filter grille (1) and (if present) the
active carbon filter. Unfasten the two Torx
screws on both sides of the extractor hood
and remove the frame and the glass. Replace
the fluorescent tube.

Ordering carbon filters

Type LSK 950 LSK 980 LSK 990
Startset*
SKF 900
SKF 950
~
SKF 980
~
SKF 990
~
SKF 995
Carbon filter: KF 90
* The start set is once only

Cleaning

Cooker hood
Clean the cooker hood with soapy water and a
soft cloth, then wipe with clean water to rinse.
Do not use aggressive cleaning agents such
as soda. The cooker hood paintwork will stay
looking nice if you wax it occasionally.
Stainless steel canopy hoods
Do not use any sort of scourer. Treat with
Stahlfix (supermarket) and polish with the
structure of the stainless steel.
Filters
Wash aluminium filters, every week in
soapy water. The cleaning agents will
make the aluminium filter turn dull, this is
normal.
The carbon filters cannot be cleaned to use
again.
LSK990G LSK991 LSK 995 SKE 900 SKE 925
~
~ ~
~
~