5 Installation
5.3 Mounting the canopy hood
•
Mount the extractor hood against
the wall using the plugs and screws.
Start with screw A, after which you
can align the extractor hood using a
spirit level and the jack screws. (See
images).
•
Next, mount the bracket on the wall
using the plugs and the screws.
•
Install the discharge fl ange on top
of the motor frame (B). Now put the
electric unit upright and install it onto
the motor frame (C) using 2 screws
•
Install the vent duct on the fl ange (C)
and then onto the connecting surface
of the exhaust grid.
•
Put the plug in the wall socket.
•
Slide the upper chimney into the
lower chimney.
•
Wrap the lower duct around the
motor frame and let it sink into the
extractor hood.
•
Wrap the top duct around the bracket
and tighten with the screws.
A
B
C
A
45