General; Mounting The Canopy Hood - Pelgrim LSK Série Notice D'utilisation

General

This appliance should be connected to the
power supply by a recognized fitter who is
familiar with, and works according to the
correct safety regulations. This appliance
meets the European requirements CEE 89/336
EMC and CEE 73/23; 93/68 LVD.
Important that you know
If the cooker hood is to be fitted to an
existing duct no other appliances, such as
a geyser or heater, may be connected to
that same duct.
Consider local regulations with respect to
the ventilation of gas appliances!
The cooker hood should be mounted at
least 650 mm above the hob.
The shorter the duct, and the fewer the
bends in it, the better the cooker hood will
work.
Before you start drilling check that there
are no installation cables present.
The diameter of the outlet flange is 125 mm,
a duct with the same diameter is best.

Mounting the canopy hood

See fig. 9 and 10.
A - Assembly screws for chimney.
B - Fixing bracket.
C - T-piece for recirculation model (in the
start set).
D - Duct flange.
E - Fixing bracket.
F - Outlet grille for recirculation model.
G - Baffle for recirculation model (in the start
set).
H - Duct flange.
S - Canopy hood mounting bracket with
adjustment screw.
First determine the position and distance
with regard to the mounting brackets. Mark
the holes that must be drilled and drill the
4 holes.
Fix brackets (B + E) to the wall with the
plugs and screws provided.
Press the two flange halves (D) firmly
together, so that a snap connection is
made, then screw the assembled flange (D)
onto the canopy hood.
Hang the hood on the wall bracket and
drive 2 adjustment screws (S) into the
brackets. These screws can be adjusted to
make sure that the hood hangs absolutely
straight.
Note: Some canopy hoods do not have
separate mounting brackets but are
screwed directly on the wall.
On the back of the canopy hood are 2 holes
with a diameter of 8mm for the
2 plugs/screws to fix the hood.
Connect the duct. If the recirculation
system is to be applied mount the T-piece
(C) or the baffle (G) instead of a duct.
Fit the short cylinder to the mounting
bracket (B) and pull the long cylinder to the
top of the canopy hood.
Screw the chimney in place from the inside
of the canopy hood (remove filters).