Using The Battery Monitor - Mobicool T26 DC/AC Notice D'emploi

T26_32_DC-AC.book Seite 10 Freitag, 14. März 2008 3:19 15
Operation
5.3

Using the battery monitor

(Only on versions with the additional ABS feature)
If you operate your cooler with the 220-240 V AC mains supply,
switch off the battery monitor.
➤ Push the switch (3 2, page 3) on the operating panel to "ON" to switch
on the battery monitor.
✓ The red LED (3 1, page 3) on the operating panel displays the status of
the battery monitor:
Operating display Operating mode
LED glows
LED flashes
➤ Push the switch (3 2, page 3) on the operating panel to "OFF" to switch
off the battery monitor.
5.4 Changing the lid
(Only on versions with the additional insulating lid feature)
As an alternative to the unit lid, you can use an insulating lid when transport-
ing the cooler.
➤ Fold the handle of the cooler forwards.
➤ Open the lid until it is vertical and then remove it by lifting it upwards.
➤ Place the insulating lid with the guide lugs into the slots on the cooler.
Please remember: the insulating led is only suitable for trans-
port and not for cooling.
10
The switch-on voltage (13.1 V ± 0.2 V) is present
and the cooler is in operation.
The switch-off voltage (11.7 V ± 0.2 V) has been
reached and the battery monitor has switched off
the cooler.
T26 DC/AC, T32 DC/AC