Scope Of Delivery; General Safety Instructions - Güde HWW 3100 K Traduction Du Mode D'emploi D'origine

Every effort is made to improve our products continuously. Therefore, technical data and figures are subject to change
Unit

Scope of Delivery

# 94667 – HWW 3100 K
Fig. 8
Guarantee
A warranty period of 12 months applies to commercial use and 24 months apply to private use and commences on the day of
purchase of the device.
Warranty applies exclusively to failures due to defective material or workmanship. An original sale slip with indication of date of sale
must be presented in case of claiming for the warranty rights.
Warranty does not cover unprofessional use such as device overload, violent use, damage caused by third party or foreign materials,
failure to comply with operations and assembly manual, and normal wear and tear.

General Safety Instructions

Prior to the initial use of the unit, the operating instructions should be read completely. If in doubt with regard to connection and
operation of the unit, consult the manufacturer (servicing department).
Follow the instructions below carefully in order to secure a high degree of safety:
Caution: Always operate with FI (stray current protection switch)!
The pump should never be operated as a swimming pool circulating pump.
 The pump should not be used in swimming pools. Only professional is allowed to do the electric installation. The pump should be
fed vi a stray current protection switch dimensioned at 30 mA max.
 Do not let the pump dry-run without any water supplied. It would threaten the service life of the pump and damage the motor.
 Never wrap the pump head in a blanket or a cloth in an attempt to prevent the water getting frozen in a cold weather.
 Never use the pump at the outdoor temperature above 40°C or below 0°C and with water at the temperature above 35 °C.
 Take care no to use the pump with r fluids other than water
 Avoid water with sand, it may damage the sealing.
 Read instruction for operation carefully before assembly and putting in operations and follow the instructions with care. Persons
not familiar with the pump operation are recommended to read the operation and maintenance manual thoroughly prior to putting the
unit in operation so that the risk of damaging it is avoided.
 The user is to be held liable to third persons while at the workplace
 The pump should not be put in operation unless equipped with a cable or a rubber-coated extension cable type H07RNF, subject
to standards DIN 57282 or DIN 57245.
 The pump should not be lifted, fixed or moved by connecting electric cable
 You should make sure that the plug connections are protected from the moisture and possible floods.
Check to see that the connecting cable and the plug are in good order before the use. Place the pump ob a flat, stable, horizontal

base.
 Unplug the pump before doing any work on it.
 The user shall be held liable for observing the local safety and assembly regulations.
 If the pump is defective, only an authorised workshop should do the repair. Only genuine spare parts should be used.
Ideal to supply households, gardens, farms and agricultural
areas with water
1. Pump connection
2. Filler cap and bleed screw
3. Suction connection
4. Pressure hose
5. Pressure switch
6. Air receiver feet
7. Air receiver
8. Pump body
9. Drain screw
10. Air valve
11. pressure gauge
12. Air valve
13. Manometers
12